Install The Tray/Shelf; Glide Adjustment; Door Adjustment - Gladiator Modular GearBox Cabinet Instrucciones De Ensamblaje

Install the Tray/Shelf

Removing the Tray/Shelf
1. Unload the contents from the tray/shelf.
2. Slide the tray out to fully open position.
3. Press the lever down on the right-hand track and lift the lever
up on the left-hand track to release tray. Continue to pull the
tray until it comes free.
1
Replacing the Tray/Shelf
1. Align the tray guides with the receiving glides.
2. Holding the receiving glides firmly in place, insert the tray
guide.
NOTE: It is normal for the tray/shelf to close tightly the first time
after it has been removed.
3. Push tray/shelf in completely.
Changing from Tray to Shelf
To accommodate your storage needs, the tray inverts easily to
become a shelf. Follow the steps for removing the tray/shelf, and
flip the tray/shelf over before following the steps for replacing the
tray/shelf.
1. Lever

Glide Adjustment

(optional)
For storage flexibility, you can remove the tray/shelf glides and
reinstall them at the desired height.
Removing the Tray/Shelf Glide
1. Back of glide
1. Unload the tray/shelf and remove (see "Install the Tray/
Shelf").
2. Insert flat-blade screwdriver behind the first slot between the
glide and cabinet panel.
3. Using the screwdriver, pry the glide away from the cabinet
panel while pushing the glide toward the rear of the cabinet
until the glide comes free.
Replacing the Tray/Shelf Glide
1. Determine desired height for tray/shelf.
2. Insert glide tabs into the openings in the cabinet panel.
3. Holding onto the back of the glide, pull it toward you until it
locks into place.
4. Replace the tray/shelf (see "Replacing the Tray/Shelf").

Door Adjustment

The cabinet is designed with adjustable doors.
1. Using a Phillips screwdriver, loosen all screws attaching the
hinge to the cabinet.
2. Adjust door to the desired height
3. Tighten the screws.
1
5