Página 1
Graphical Operator Interface Type ABS CA 511 2013.08.21 05:56:19 Low level 1.55 m 0.15 kWh/m3 PUMP 1 980.3 l/s 1827 l/s 1.30 m 1.50 m 1.70 m 1.90 m 0.50 m 0.55 m ...
Página 2
The content of this manual is furnished for informational use only, is subject to change without notice, and should not be construed as a commitment by Sulzer. Sulzer assumes no responsibility or liability for any errors or inaccuracies that may appear in this book.
Graphical operator interface type ABS CA 511, Installation guide INSTALLATION General information The operator panel CA 511 communicates through the CAN-bus. The operator can easily configure and monitor the system from the operator panel. 1.2 Installation of the operator panel When installing the CA 511 it is required a rectangular hole with the height of 107 mm and width of 220 mm.
Página 4
Graphical operator interface type ABS CA 511, Installation guide 1.4.2 CAN Termination The CAN bus shall be terminated at both cable ends. PC 441 is bus master and has a built-in termination that are always active and should therefore always be placed in one of the endpoints of the cable.
Graphical operator interface type ABS CA 511, Installation guide TECHNICAL DATA Technical data CA 511 Ambient operation temperature -20 to +50°C (-4 to +122°F) Ambient storage temperature -30 to +80°C (-22 to +176°F) Degree of protection assembled in IP 65, NEMA: Type 4...
Página 6
Graphical operator interface type ABS CA 511, Installation guide This page is intentionally left blank.
Meno a adresa osoby oprávnenej na zostavenie technického súboru pre úrady na požiadanie: Asmens, įgalioto valdžios institucijoms pareikalavus sudaryti techninę bylą, vardas, pavardė ir adresas: Frank Ennenbach, Director Product Safety and Regulations, Sulzer Management AG , Neuwiesenstrasse 15, 8401 Winterthur, Switzerland Declare under our sole responsibility that the products: Försäkrar under eget ansvar att produkterna:...