Technical Specifications; Need Help - Philips SBCLI800/00 Modo De Empleo

XP SBC LI 800 18-04-2002 15:42 Pagina 7
Troubleshooting
If a fault occurs, first check the points listed below. If you are unable to
remedy a problem by following these hints, contact the helpline (see next
paragraph) or consult your dealer.
Under no circumstances should you try to repair the set yourself as this will
invalidate the guarantee.
The set should work with almost any remote control, except for some
brands mentioned in the previous paragraph.
In case the set does not work, check the following points:
• Are both transmitter and receiver connected to the mains supply?
• Does the remote control have fresh batteries?
• Is the distance between remote control and transmitter greater than
7.5 meters?
• Are their obstacles between remote control and transmitter?
• Is the receiver in line of site and facing the equipment to operate?
If this is not possible, connect the extension cord.
• When using the extension cord:
check if IR lights are properly attached to the IR sensors of your
equipment.

Technical specifications

Power supply: 230-240 VAC / 50 Hz
Transmission type: RF-transmission
IR carrier frequency: 32k-40kHz

Need Help?

In case you have any questions about the LI 800, please contact our help-
line for assistance! You can find the number in the list on page 2.
Before you call, please read this manual carefully.
You will be able to solve most of your problems.
The model number of the remote control extender is SBC LI 800.
Date of purchase: _____
day/
ENGLISH
/_____ /______
month /year
7