Using The Wall-Mounted Door Control; To Open The Door Manually - Sears Craftsman 139.53992 Manual Del Propietário

Using the Wall-Mounted
Door Control
THE PREMIUM CONTROL CONSOLE
Press the lighted push
button to open or close the
door. Press again to
reverse the door during the
closing cycle or to stop the
door while it's opening.
Light feature
Press the Light button to turn the opener light on or
off. It will not control the opener lights when the door
is in motion. If you turn it on and then activate the
opener, the light will remain on for 4-1/2 minutes.
Press again to turn it off sooner. The 4-1/2 minute
interval can be changed to 1-1/2, 2-1/2, or 3-1/2
minutes as follows: Press and hold the Lock button
until the light blinks (about 10 seconds). A single blink
indicates that the timer is reset to 1-1/2 minutes.
Repeat the procedure and the light will blink twice,
resetting the timer to 2-1/2 minutes. Repeat again for
a 3-1/2 minute interval, etc., up to a maximum of four
blinks and 4-1/2 minutes.
Lock feature
Designed to prevent operation of the door from hand-
held remote controls. However, the door will open and
close from the Door Control, the Outdoor Key Switch
and the Keyless Entry Accessories.
To activate, press and hold the Lock button for two
seconds. The push button light will flash as long as
the Lock feature is on.
To turn off, press and hold the Lock button again for
two seconds.The push button light will stop flashing.
The Lock feature will also turn off whenever the Learn
button on the motor unit panel is activated.
Additional feature when used with the 3-function
hand-held remote
To control the opener lights:
In addition to operating the door, you
may program the remote to operate
the lights.
1. With the door closed, press and hold a small
remote button that you want to control the light.
2. Press and hold the Light button on the Premium
Control Console.
3. While holding the Light button, press and hold the
Lock button on the door control.
4. After the opener lights flash, release all buttons.

To Open the Door Manually

• To prevent possible SERIOUS INJURY or DEATH from
a falling garage door:
LIGHTED – If possible, use emergency release handle to
PUSH BUTTON
disengage trolley ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced
LIGHT BUTTON
door could result in an open door falling rapidly
LOCK BUTTON
and/or unexpectedly.
– NEVER use emergency release handle unless garage
doorway is clear of persons and obstructions.
• NEVER use handle to pull door open or closed. If rope
knot becomes untied, you could fall.
DISCONNECT THE TROLLEY:
The door should be fully closed
if possible. Pull down on the
emergency release handle (so
that the trolley release arm
snaps into a vertical position)
and lift the door manually. The
lockout feature prevents the
trolley from reconnecting
automatically, and the door can
be raised and lowered manually
as often as necessary.
TO RE-CONNECT THE
TROLLEY:
Pull the emergency release
handle toward the opener at a
45° degree angle so that the
trolley release arm is horizontal.
The trolley will reconnect on the
next UP or DOWN operation,
either manually or by using the
door control or remote.
32
WARNING
CAUTION
AVERTISSEMENT
ATTENTION
Lockout position
(Manual disconnect)
Emergency
Release
Handle
(Pull at 45° angle)
To reconnect
Trolley
Trolley
Release Arm
(in Manual
Disconnect
Position)
Trolley
Trolley
Release
Arm