Removal From Window - Sears Kenmore 580.72059200 Manual Del Propietário

r"_ INSTALL THE AIR CONDITIONER IN THE
WtNDOW
• Carefullyliftthe air conditionerand slideit intothe open
window.Make surethe bottomguideof the air
conditionerdropsintothe notchesofthe L brackets.
• When the air conditionerdropsintothe L brackets,the
air conditioner w ill be centeredin windowopeningas
shown in FIG. 7.
• While steadying the air conditioner, carefully bring the
window sash down behind the upper guide of the air
conditioner, as shown in FIG. 8.
WINDOW FRAME_
UPPER (
CENTER LINE _
FIG. 7
ABOUT V4"
BOrG
GUIOE
LBRACKET
FIG. 8
_--_ SECURE THE GUIDE PANELS
Extend the guide panels (ITEM F) to fill the window
opening using 4 screws (ITEM B) to secure them, as
shown in FIG. 9.
_ INSTALL THE SASH SEAL AND SASH LOCK
• Cut the foam seal (ITEM E) to the window width.
Stuff the foam seal between the glass and the windowto
prevent air and insects from getting into the room, as
shown in FIG. 9.
• Fasten the remaining L bracket on either side of the
window using screw (iTEM A). See FIG. 9 inset.
Installing this bracket prevents window from being raised
which may result in unit falling.
• Remove the screws that secure the cabinet and base
pan in the right side.
• Attach the support bracket (ITEM H) in the inner window
sill with a screw (ITEM B), as shown Fig. t0.
__' Support Bracket (ITEMFIG.
10H)
I_IF AIRCONDITIONER IS BLOCKED BYSTORM
WINDOW FRAME
• If stormwindowpresents interference, f asten a 2" wide
woodstripto the innerwindowsill across the full width of
the sill.The woodstripshould be thickenoughto raise
the heightof the windowsill so thatthe unit can be
installedwithoutinterference from the the stormwindow
frame. See FIG. 11.
Top of woodsthpshould be approximately3/4" higher
than the storm window frame to help condensation to
drain properly to the outside.
• Install a second wood strip (approximately 6" long by
1_/2"wide and same thickness as first strip) inthe center
of the outer sill flush against the back of the inner sill.
Screw the L brackets intothis strip.
This will raise the L bracket as shown in FIG. 11.
WOOD STRIP MOUNTED 1" MAX
ON TOP OF INNER SILL _1 _ 3/4' ±
_ ! _ CLEARANCE T
INN E_RS_AT_K_P _ S'LL OUTER SILL FRAME
TSIDE
FIG.
11
REMOVAL FROM WINDOW
Turn the air conditioner off, and disconnect the power
cord. Remove the L bracket and the screws installed
through the top and bottom of the guide panels, and save
for reinstallation later. Close the guide panels. Keeping a
firm grip on the air conditioner, raise the sash, and
carefully tilt the air conditioner backward, draining any
condensate water. Lift the air conditioner from the window
and remove the sash seal from betweenthe windows.
--_ FIG 9
• Airconditioners coveredin this manualposean
excessiveweighthazard.Two or morepeopleare
neededto moveand installthe unit.
To preventinjuryor strain,useproperliftingand
carryingtechniques whenmovingunit.
• Whenhandlingthe air conditioner, b e carefulto avoid
cutsfromsharpmetalfins on frontand rear coils.
• Makesureair conditioner doesnotfall duringremoval,
-7-