Aleratec Charge and Sync Station 16 Guia De Inicio Rapido página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Using the Charge and Sync Station 16
Connection -•Continued
3. If syncing, use the USB A to B cable provided and connect the USB B
end on the unit. Connect the USB A end to your host computer. Unplug
the USB cable if charging your devices.
Sync times will vary greatly depending on a variety of factors
including, but not limited to, your computer and the amount of data
being synced.
Please note that this station only serves as a pathway for
communication between your devices and the computer. Actual
management and synchronization is handled by software or apps
independent of this station.
After syncing, eject each device properly from the computer before
disconnecting or powering off.
4
www.aleratec.com

Publicidad

Tabla de contenido
loading

Productos relacionados para Aleratec Charge and Sync Station 16

Este manual también es adecuado para:

4001034000103

Tabla de contenido