Publicidad
Idiomas disponibles
Idiomas disponibles
Parts List & Assembly Instructions
CAUTION: To prevent personal injury or equipment damage,
•
The owner of the press is responsible for the press being installed and operated according to
federal (OSHA), state, and local safety standards.
•
Wear eye protection that meets ANSI Z87.1 and OSHA standards.
•
Read, understand, and follow all safety precautions and operating instructions included with
the press. Safety-related decals must be installed, maintained, and replaced if they become
hard to read.
•
Keep hands out of the work area during a pressing operation.
•
Work pieces must be well supported and aligned so that ram force is straight, and parts being
pressed cannot slip out or break.
•
Locate the press in an isolated area or shield the press to minimize danger to others.
•
It is impossible for the manufacturer to provide practical "all-purpose" shielding because this
is a general purpose press that can be used in many different ways. The owner of the press must
provide shielding that is practical and necessary for each application. Some protection is
provided by wrapping the piece in a protective blanket before applying pressure. (Protective
blankets are offered in the OTC catalog.)
•
Do not stress adapters beyond their capacities; adapters used with this press must have a maximum tonnage
rating equal to or higher than the maximum tonnage rating of the press.
This press can exert an extremely high force at a moderate hydraulic pump pressure. If you have any questions
concerning an application, or how much force is exerted at a given pressure, please contact Technical Services.
1. Place the frame assembly on its side, resting on
one of the uprights. Slide the lower bolster onto
the frame assembly from the bottom. Insert a pin
through the closest hole on each side under the
desired bolster position.
2. Assemble a foot angle to the bottom of each
3
upright using
/
" cap screws and nuts.
8
3. Lift the press to a vertical position.
4. Remove the pipe plug from the cylinder, and
install the straight fitting.
5. Assemble the pump mounting plate to the press
3
frame using
/
" cap screws and nuts. Assemble
8
the pump to the mounting plate as shown.
6. Thread the cylinder into the mounting plate until
the cylinder threads are flush with the bottom of
the plate (full thread engagement.) Adjust the
position of the cylinder so the fitting faces the
pump side of the press.
7. Assemble the hose between the cylinder and
the pump.
Refer to any operating instructions included with the product for
detailed information about operation, testing, disassembly,
reassembly, and preventive maintenance.
Items found in this parts list have been carefully tested and selected
by OTC. Therefore: Use only OTC replacement parts!
Additional questions can be directed to our Technical Serv. Dept. at
1-800-533-6127.
Form No. 102766, Sheet 1 of 1, Back
Safety Precautions
Assembly Instructions
Pump
Pump
Mounting Plate
Frame
Assembly
Foot Angle
Hose
Lower
Bolster
3/8" Cap Screws & Nuts
Cylinder
Pin
Publicidad
