Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATOR'S MANUAL
INSTRUCTIONS PERTAINING TO THE RISK OR INJURY TO PERSONS.
IMPORTANT SAFETY INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
READ THIS MANUAL CAREFULLY BEFORE INSTALLING,
OPERATING OR SERVICING THIS EQUIPMENT
D NGER G SOLINE – EXTREMELY FL MM BLE
• VAPORS CAN EXPLODE
• Do not store in vehicle or living space.
• HARMFUL OR FATAL IF
• Store and use in well-ventilated area.
SWALLOWED
• Vapors can be ignited by a spark or flame source many feet
• If swallowed, do not induce vomiting.
away.
Call physician immediately.
• Keep away from flame, pilot lights, stoves, heaters, electric
• Keep out of reach of children.
motors and other sources of ignition.
• Avoid prolonged breathing of vapors.
• Keep container closed.
• Do not siphon by mouth.
• Do not smoke near or while using this fuel cart.
W RNING
• When using this product basic precautions should always be followed, including the following; A) Read all instructions before
using this product. B) To reduce the risk of injury, close supervision is necessary.
• Ensure that all fittings and connections are tightened and leak free.
• Do not modify this tank, fittings, valves, or caps.
• Place container in horizontal position on ground when filling.
• Discharge static electricity before fueling by touching a metal surface away from the nozzle.
• Keep nozzle in contact with the container while filling. Do not use a nozzle lock-open device.
• Do not get back in vehicle while refueling. Re-entry could cause a static build up.
• Fill slowly to prevent the build up of static charges.
• If fire starts, do not remove nozzle. Back away immediately.
• Closely monitor flow to prevent spills and overfilling.
• Perform the entire closure procedure before using the fuel cart to transport fuel.
• Secure or strap container to trailer or truck bed. Do not place inside a vehicle trunk or inside passenger compartment.
• Do not use electronics or mobile phones while using this product.
• Regulations for the transportation of gasoline vary from state to state, even locally. It is the vehicle operator's responsibility
to review and comply with all federal, state, and local regulations.
• Review and comply with all building and fire codes concerning the proper storage of fuel. It is the owner's/user's
responsibility to comply with all building and fire codes.
• Do not store in direct sunlight.
C UTION
• Use fuel cart for "one type of fuel only" to avoid possible contamination or damage to equipment or motor vehicles.
• Use care when maneuvering to prevent injury or loss of control. Seek assistance to avoid strain or injury when required.
Capacity and Dimensions: GG-15PFC
Fill capacity vertical:
16.5 gal. (62.7 liter)*
Fill capacity horizontal:
16.5 gal. (62.7 liter)*
Tare Weight:
28.0 lbs (12.7 kg)
Gross Weight (15 gal of fuel): 119.1 lbs (54.0 kg)*
Dimensions (horizontal):
34.5 (L) x 22.25 (W) x 16.75 (H)
*when filled to just below the bottom of filler neck
2.
GG-15PFC/GG25PFC FUEL CART
Capacity and Dimensions: GG-25PFC
Fill capacity vertical:
25.0 gal. (94,6 liter)*
Fill capacity horizontal:
22.5 gal. (85,1 liter)*
Tare Weight:
32.0 lbs (14,55 kg)
Gross Weight (25 gal of fuel):
192.0 lbs (87,1 kg)*
Dimensions (horizontal):
43 (L) x 23 (W) x 18 (H)
*when filled to just below the bottom of filler neck
OPERATOR'S MANUAL
Assembly Instructions
1. Wrap both hose fittings with PTFE tape.
2. Connect bolt valve the 90° elbow by positioning the valve against the fitting and tighten
the nut as shown in Figure A.
3. Assemble nozzle onto 3/4" NPT end as shown in Figure B and tighten.
4. The tires are not inflated prior to shipment. Inflate both tires to 15 psi (1.0 bar) before
using.
To fill container
1. Confirm the filling location is safe and away from all sources of ignition, sparks, and
flames.
2. Place the fuel cart container on the ground in horizontal position (valve and fill cap up)
away from vehicle before filling. Placing the container on the ground allows a path for
static charge to dissipate.
3. Dissipate any static electricity by touching a metal surface away from the nozzle prior to
removing nozzle from dispensing pump
4. Remove fill cap and insert service station dispensing nozzle into the filler neck opening.
5. Keep the service station dispensing nozzle in contact with the container opening while
filling. DO NOT use nozzle lock-open device. DO NOT re-enter vehicle while filling your
fuel cart or while refueling your vehicle. Re-entry could cause a static build up.
6. Fill slowly to prevent the build up of static charges. Stop immediately if you sense the
build up of static charges (sensation of hair raising or tingling of parts of body).
DO NOT resume filling until static charges dissipate.
7. Closely monitor flow to prevent spills and overfilling the container.
8. Do not fill above the bottom of the threaded filler neck.
9. Reinstall the fill cap.
10.Wipe any residual fuel from outside of tank or allow to evaporate.
To dispense from container
1. Position tank in upright vertical position.
2. Slowly crack open fill cap to vent any internal pressure.
3. Open the ball valve handle clockwise as shown to be inline with the flow in the hose.
4. Place tip of nozzle into container that is being filled. The nozzle must remain inside the
container while dispensing.
5. Fuel is gravity dispensed through nozzle. Squeeze handle to begin flow, release to stop.
6. Monitor flow and liquid level to prevent spills.
7. When finished drain remaining fuel back into the tank per the instructions below.
To drain fuel from hose back into the container
1. Lay fuel cart in horizontal position (valve and fill cap up).
2. Elevate the nozzle above the hose, and slope the hose back to the valve to
provide a clear path for fluid to drain.
3. With the nozzle above the hose, squeeze the handle of the nozzle to allow hose to vent
and fuel to drain back into the tank.
4. Close the ball valve.
To close for transportation or storage
Return all fuel from hose back into tank per above instructions.
1 Close the tank
a. Close ball valve by turning the handle until it stops in 90° position as shown.
This indicates that the ball valve is in the closed position.
b. Turn fill cap in direction as shown until the cap seats on tank, then turn an
additional 1/4 turn.
c. Turn manual vent in direction as shown until closed, then turn an additional 1/4 turn.
GG-15PFC/GG25PFC FUEL CART
3.
Publicidad
