Technical Informations - ARDES 2440 Folleto De Instrucciones

During use, hold the machine on a flat surface.
During use, position the cable so as to avoid contact with the flame or
excessively hot surfaces.
1 - Motor unit
2 - Switch
3 - Power cable (100 cm long)
4 - Bracket for fastening the motor unit
5 - Screw for Adjusting the paddle centring.
6 - Retaining clip
7 - Aluminium paddle
8 - Supports
9 - Pot made of copper approved for contact with food.
10 - Handle
Technical data indicated on the appliance.
Fitting the paddle (Fig. 2).
Push the paddle pin (7) into the shaft of the motor unit (1).
Insert the catch (6).
Fastening the motor unit on the pot (Fig. 3).
Fit the drive motor on the pot from above, placing the bracket as shown
in Fig. 3. To remove the motor unit, just slide it out by pulling it upwards.
Plug in the appliance, start up the motor unit by switching it on (2) and
make sure that the paddle turns smoothly without touching against the
sides of the pot. If not, switch off, disconnect the appliance and read
carefully the chapters on the settings.
10

Technical informations

Instructions for use
GB
GB