Holiday Living & Design 66933-67 Guia De Inicio Rapido página 4

ASSEMBLY INSTRUCTIONS
2. Carefully insert bottom section (D) of tree into stand.
Make sure pole is firmly inserted into stand and
tree stand screw (F) is tightened.
NOTE: 2 metal screws are included with the stand.
Only one is required; the second screw is a spare.
3. Insert lower middle section (C) of tree into bottom
section (D). Extension cord from section (C) should
run down through section (D) and toward wall outlet.
DO NOT PLUG INTO WALL OUTLET UNTIL
ASSEMBLY IS COMPLETE!
4. Locate plug labeled #3 from section (D) and
connect to outlet labeled #3 mounted in section (C).
IMPORTANT: Do not remove the tape wrapped
around the outlets of the light set cords. Any outlet you
need to plug into is NOT wrapped in tape and is clearly
labeled. Only remove tape when inspecting fuses
(see Troubleshooting section). There is a yellow tag
attached to the extension cord to help locate the outlet
on the cord to insert the plug.
2
3
E
4
C
3
E
4
D
F
E
C
D
D