Assembly - Husky HOAA52JX1 Guía De Uso Y Mantenimiento

Assembly

A. Mounting the Pegboard to
Husky Mobile Workbench
WARNING: Use special care to not over-tighten any of the
screws to avoid damage to the pegboard or mobile workbench.
1 . Place the right support post (F) on the back of the mobile
workbench. Ensure the support post is flush and level.
Attach the right support post (F) to the back of the mobile
workbench using four screws (BB).
2 . Repeat step 1 for left support post (E) .
F
3 . Attach the left pegboard panel (A) to the left support post (E)
using four screws (BB). Secure the pegboard to the post,
but do not tighten at this time.
E
BB
A
E
6 6
4 .
Insert the middle pegboard panel (C) to the left pegboard (A)
and push it to the deepest position.
5. Attach the right pegboard panel (B) to the right support post (F)
using four screws (BB). Secure the pegboard to the post,
but do not tighten at this time.
6.
Pull the middle pegboard panel (C) back to middle position.
BB
F
A
C
B