Peltor SportTac MT16H210F Serie Manual De Instrucciones página 6

Remove the batteries when storing the hearing protector for a long time. Check the function of the
unit after replacing the batteries.
REMOVING/REPLACING THE EAR CUSHIONS
(E:7) Insert your fingers under the edge of the ear cushion and pull straight out
(E:8) Insert the new ear cushion by pressing it in until it snaps in place
SPARE PARTS/ACCESSORIES (F)
HY68 Hygiene kit
Easy to replace hygiene kit consisting of two attenuation cushions and snap-in ear cushions.
Replace at least twice a year to ensure constant attenuation, hygiene and comfort, or if any of the
parts of the hygiene kit are defective. The headset and particularly the ear cushions can degenerate
over time and should be inspected regularly to ensure that there are no cracks and sound leakage.
If an ear cushion is damaged, it must be replaced; see the CARE section.
HY100A Clean single-use protectors
A single-use protector that is easy to apply to the ear cushions. Packages of 100 pairs. Installing
single-use protectors can affect the hearing protector's acoustic properties.
Receive-Only Audio Input cables
FL6H 3.5-mm mono plug
FL6M 2.5-mm mono plug
FL6N 3.5-mm stereo plug for Micman com radio
Two-way communication audio cable
TAMT06 Cable with PTT and microphone, J22 plug
Y-cables
FL6AC Wired as fig. F:1
FL6AF Wired as fig. F:2
MT7-FL6AB Headset kit (F:3)
Product models with no microphones can be converted into headsets by the addition of a boom
microphone on one of the guide wires or a throat microphone (MT9). The microphone connects to
the audio input via a Y cord and then to an external radio. Wired as fig. G:1
FL5000 Peltor FL5000 adapter series (F:4)
Adapters that give optimum adaptation of Peltor headsets to most communication radio models on
the market. Only available for headsets wired as (G:1).
The adapter has a functional, watertight, sturdy casing with no protruding parts. The size is designed
to fit easily in the hand, but it is also easy to attach to the clothing so that it isn't in the way and doesn't
risk snagging on anything.
* Some models have an external switch between the headset and the radio.
Boom microphones
MT70-05 fig. (F:5)
MT21 fig. (F:6)
HY400 Head pad
For optimal fitting on smaller head sizes, use head pad HY400. The head pad is easily attached to the
standard head pad, please see fitting instruction (F:7)
Outer shells (including Wind protector for level dependent microphones and clip). The outer shells
are replaceable. Shells are available in a number of different colours and easy changeable. For
instruction on how to replace shells, please see CARE section.
4