Cleaning And Maintenance - Bimar MS107 Folleto De Instrucciones

Fax +32 030 9904733
Warning: the blender should only be used in an upright position, with the blades pointing downwards.
Using the appliance
• Before each use, check that the equipment is in good condition, that the wiring is not damaged: if
the power cable is damaged, it must be replaced by the manufacturer or its technical assistance
centre or by someone who is similarly qualified, in order to prevent any risks.
• Add the ingredients to be processed:
- in a suitable and equal sized container, it is advisable to use a tall and straight container, with
a diameter greater than the engine body in order to allow the ingredients to blend smoothly;
never fill the container above the shaft
- directly in a pot, after having removed it from the heat source and allowed it to cool to avoid
overheating the ingredients; for best results, never fill the pot above the shaft
• Allow hot ingredients to cool before processing them or pouring them into the beaker (max temp.
80 ° C).
• Plug into the power point.
• Dip the shaft into the ingredients before putting it into operation. This will help avoid splashing
when you turn the engine on.
• During use, it is necessary to hold the container with the ingredients firmly with one hand and the
engine body with the other.
• The engine body is equipped with a pressure switch (A) with one speed: press the speed to operate
the engine and vice versa release it to turn it off.
• The appliance can operate continuously for up to 60 seconds, after which requires a break of at least
10 minutes before using it again. Failure to do this may affect the performance of the appliance. It
is recommended to use the appliance for short on / off periods: this will improve the preparation of
food, and this ensures a longer life of the engine.
• If the blades get blocked, disconnect the appliance from the mains and remove the ingredients that
are blocking the blades.
• When you having finished using the blend: release the switch, wait for the blades to come to a
complete stop and remove the plug from the socket.
If the appliance is not in use for long periods of time, remove the plug from the plug point.

CLEANING AND MAINTENANCE

Warning:before cleaning the appliance, turn it off and unplug it from the mains. The appliance and
all the parts which come in contact with food (shaft with blades) require careful cleaning after each
use. To remove the shaft into engine body, then turn the shaft counterclockwise direction in time
symbol .
• Some types of food, carrots for example, can cause discoloration of the plastic. To remove stains
from discoloration, it can be helpful to rub the affected parts with a cloth dipped in vegetable oil.
• Be careful when preparing food for babies, the elderly or sick people. Always make sure to
thoroughly sterilise the shaft using a sterilising solution in accordance with the instructions
provided by the manufacturer.
• To clean the shaft and blades (the blades are sharp: be careful), use a soft sponge with warm water
and household washing up liquid. Then rinse with plenty of water under a running tap, and dry
thoroughly. Do not use steel wool or abrasive products. The shaft with blades can be washed in the
dishwasher.
• Engine body: must only be cleaned with a soft cloth that has been slightly dampened either with
just water and/or detergent. It cannot be washed in the dishwasher or even under the running water:
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
9/28
Assembly page 9/26