Drive RTLREB18DDA-SF Manual De Instrucciones página 6

use and safety
Wheel Locks - Engage both wheel locks before getting in or out of chair, leaning
forward in chair, or while in an elevator or wheelchair lift. Proper adjustment of wheel
lock is at least 1/8" when locked. Locks are engaged by pushing handle completely
forward. Adjustments to locks are made by loosening or tightening nut on the carriage
bolt. Embed lock shoe at least 1/8" by sliding clamp toward rear wheel while handle is
engaged in locked position. Tighten nut and bolt to secure in position. Test for correct
locking action before actual use.
Tires - Solid rubber tires need minimal maintenance, but should be cleaned occasionally
with a damp cloth. Replace if tires become severely worn or cracking appears.
Removal of Swing-away Foot rests/Leg rests - Release lock by pushing on the front
rigging lever. Swing-away foot rest out and sideways. Lift to remove.
General Care - Wipe chrome parts with a clean, soft cloth at least once a week. All
metal parts can be cleaned with auto wax or similar poducts. If exposed to moisture, dry
immediately. Do not use an abrasive cleanser that will scratch the finish.
To Open Chair - Open wheelchair by tilting to one side and pushing down on seat rail
until fully opened.
To Close/Fold Chair - First fold foot plates to vertical position. Grab seat with both
hands at front and back edge and lift. Or, tilt chair to one side and lift up on seat rail.
Removable Arms - Remove arms by depressing spring button and lifting arms out of
front and rear sockets.