Installation Instructions - Allen + Roth Reagan 72-BVF11-BB-AR Manual Del Usuario

INSTALLATION INSTRUCTIONS

1.
Shut off the water at the supply valves under the sink or at the main water
supply. Disconnect the supply lines. Remove the existing faucet from the
sink.
Clean and dry the surface area where the new faucet will be mounted.
2.
Confirm that the hole in sink and/or countertop is 1.3 in. - 1.5 in. to accommodate
the new faucet.
Remove the preassembled lock nut (BB), and metal washer (AA) from the faucet
body (A). Before installation, make sure the flange (B) is on the bottom of the
faucet body (A). Insert the faucet body (A) through the mounting hole in the sink
(2.1). From underneath the sink, secure the faucet body (A) to the sink
using the washer (AA) and lock nut (BB). Use a wrench to tighten the lock
nut (BB).
Hardware used
AA
Washer
BB
Lock nut
3.
Remove the bottom gasket (3.1) and mounting nut (3.2) from the drain
assembly (C). Push the bottom gasket (3.1) down onto the top of the
mounting nut (3.2) and twist to attach together.
4.
Insert the drain assembly (C) into the drain hole in the sink (4.1). Ensure the top
gasket (4.2) rests securely between the top of the sink and the top of the drain
assembly (C).
x 1
x 1
4
1
2
A
AA
BB
3
4
4.2
C
4.1
B
2.1
C
3.1
3.2