Telefunken TLF-AC3602 Manual De Instrucciones página 13

Starting
Insert a micro SD or micro SDHC memory; consult the following diagram to locate the
components of your camera.
SDHC Class 6 above is recommended. When the professional mode is
enabled for video recording, Class 10 is recommended for use.
Turn the camera off before removing or inserting any memory.
Please close the camera when you insert or eject the memory.
Turn on and turn off
Turn On:
Press the button for on / off and hold for about 2 seconds. Upon hearing a sound, the
camera turns on and the LCD screen will be recording mode (default); the indicator
will be in red
When the camera is not in operation for about a minute, the energy saving mode
is activated. The LCD screen turns off automatically. The camera can be activated
when any button is pressed.
Turn Off:
When the camera is not in operation, press the button for about 3 seconds. Again,
the alarm will sound and the camera turns off.
Charging the camera
The camera has a rechargeable lithium battery:
The camera can be charged when connected to the USB port of your computer via a
USB cable. The power indicator is blue when it is cargando.4 is the estimated hours
for the battery recharge time. The blue light turns off when charging is complete.
Video y Fotografía
The TLF-AC3602 camera has two modes, video recording and photo shooting.
To change between photography and recording, press the button on / off / mode or
through APP.
24 Manual de Instrucciones
Record a video:
Press the shutter to start recording video. The buzzer will send a sound
when started; the busy button (red) flashes during video recording. The
timer on the screen starts counting. Press the button video recording when
you've finished.
Take a photo:
Briefly press the button takes photography to shoot pictures after switching
to picture-taking mode. The buzzer sends 1 beep and the button will be
busy once when 1 picture is shot.
The counter will count down accordingly photos.
Menu
To enter the Menu, briefly press the gray button to move the selection cursor; press
the shutter button for confirmation; press the gray button extended to cancel the
setting or output.
Energy saving
The energy saving mode has 4 settings: OFF / 1min / 3min / 5min. When
the set time is up, the camera enters the power saving mode and the
screen turns off.
Date and Time
System time setting Language: language setting, English is the default.
Date Stamp: setting date display, OFF / date / date and time are optional.
Factory Reset
Factory reset, YES / NO optional system are: check system information
(software version); review the information on the memory card (capacity and
available space)
Format
Formatting the memory card, SI / are not optional.
Manual de Instrucciones 25