Veranda 34107611BOM Instrucciones De Instalación página 5

Top Bracket Covers:
8
a. Ensure the railing is centered between both posts
and tighten the set screws put into the metal
brackets from Step 4.
b. From under the top rail, snap the bracket cover over
the rail. Adjust the bracket cover to be ush against
the post (so the holes in the molded bracket cover
line up with the holes in the metal bracket) (Fig. 10).
c. While holding the bracket cover ush against the
post, pre-drill using a
holes underneath. Then, drive two #10 x 1
drive screws through the cover, metal bracket and
into the top rail (Fig. 11).
For Bottom Brackets:
9
a. Center rail on post. Then, using a
drill the rst hole on an angle though the bottom rail
bracket, vinyl post jacket, and into wood post
(or plastic spacer of post install kit).
b. Install the #10 x 2
Bottom Bracket Covers:
10
Slide bottom bracket covers snugly onto bottom brackets
(Fig 13).
⁄ " drill bit though the two ⁄ ⁄ ⁄
5 5 5
32 32
⁄ ⁄ ⁄ ⁄ " drill bit, pre-
5 5 5
32 32
⁄ ⁄ ⁄ ⁄ "square drive screws (Fig. 12).
1 1 1
2 2
⁄ ⁄ " square ⁄ ⁄
1 1 1
4 4
Predrill and install screws
Fig. 10
Fig. 11
Fig. 12
Fig. 13
5