Uline Bostitch H-3532 Manual Del Usuario página 2

LOADING THE MAGAZINE CONTINUED
6. Clinch Adjustment – Turn special nut clockwise
to tighten clinch and counterclockwise to loosen
clinch. Use a tool to fit 1/8" (3mm) hole (See Figure 5).
Special
Nut
NOTE: Remove adjusting tool after adjustment.
7. Depth Adjustment – Loosen front screw and adjust
to desired length (See Figure 6). When the top edge
of adjustment plate is at highest setting (#4), the
clinchers are at their shallowest penetration. If set at
lowest setting (#1), the clinchers are at their deepest
penetration.
Figure 6
NOTE: Tighten screw after adjusting stapler.
PAGE 2 OF 19
OPERATION CONTINUED
Figure 5
Clinch
Tight Loose
Tight
Medium
Loose
       ! 
" $ % 
' ( ) ! 
0 2 ( 3
4 5 6 7
4 5 6 9 @ A
4 5 6 8
USING THE STAPLER
Stapling – Grasp handle with one hand. Position on
box in line with the desired staple location. There is a
small projection on either side of the frame as an aid in
locating the position of the staple (See Figure 7). Press
trigger. Strongest closure requires end staples close to
end of box. Check packaging requirements. Test staple
clinching in a sample of the board being used. Adjust
clinch for depth of penetration and tightness.
NOTE: Always disconnect air supply:
1. Before making adjustments;
2. When servicing the stapler;
3. When clearing a jam;
4. When stapler is not in use;
5. When moving to a different work area,
as accidental actuation may occur,
possibly causing injury.
REMOVING STUCK STAPLES
WARNING! Always disconnect air supply:
1. When servicing the stapler;
2. When clearing the jam;
3. When stapler is not in use;
4. When moving to a different work area, as
accidental actuation may occur.
1. Remove the remaining stick from the magazine. Pry
jam release forward with a screwdriver (See Figure 8).
B C D E F G F C H F
Figure 7
Figure 8
0421 IH-3532