Rampage TrailGuard Instrucciones De Instalación página 5

Installation Steps
Inside the tire carrier, pull the plastic fastener securing
the rear view camera wire.
18
Using the provided 8mm bolts, 8mm Flat Washers, bolt
the factory tire carrier to the new swing away.
20
Bolt the provided Bump Stop Pad to the Bump Stop Bracket
using the provided 6mm x 30mm Allen Head Bolts, 6mm Flat
Washers and 6mm Nylock Nuts.
Then bolt the Bracket to the center support of the Swing Away.
The bracket will need to be adjusted in Step 22, after the heim
assembly has been adjusted.
22
Bolt the Heim Assembly to the Tailgate Bracket using the provided
12mm x 70mm Bolts, 12mm Flat Washers and 12mm Nylock Nuts.
Tighten hardware.
23
NOTE: Actual application may vary slightly from illustrations.
Pass the 3rd Brake Light and Camera wires through the access
19
Pass the 3rd Brake Light and Camera wires through the
access hole, towards the tailgate.
21
Page 5 of 6
hole, towards the tailgate.