Home Decorators Collection 45386 Guía De Uso Y Cuidado

TOOLS REQUIRED
Hammer Safety goggles
HARDWARE INCLUDED
AA – Aluminum mounting bar x 1
Installation
1
PREPARING FOR INSTALLATION
WARNING: Handle this mirror with care. Wear safety glasses and
goggles while handling and installing this mirror.
WARNING:
use the dry wall anchors provided.
□
desired location.
○ Oval mirror dimensions are 21 x 31 in. and can be hung
vertically or horizontally.
○ Shaped mirror dimensions are 23 x 28.5 in. and can only
be hung horizontally.
□ Use a ruler to measure and draw a small dot on the wall
indicating the desired location of the bottom center edge and
top center edge of the mirror.
□ On the mirror, use a tape measure to measure the distance
from the top edge of the mirror to the bottom edge of the
bracket attached to the mirror.
□ On the wall, use this dimension to measure from the top
center small dot on the wall down the measured distance to
determine the wall bracket placement. Make a small dot on
the wall.
□ Measure 1/2 in. above that line. Using a level and pencil,
draw a 12 in. line (length of wall bracket) This is the center
hole of the aluminum mounting bar (AA).
□ Place the aluminum mounting bar (AA) on the wall so the
side with holes is against the wall and the center hole is
Care and Cleaning
□ Use a soft cloth and glass cleaner to clean the mirrors.
□ Do not use harsh abrasives.
Use and Care Guide
Frameless Mirror
Phillips Safety gloves
screwsdriver
BB – Dry wall anchor x 3
Top Center
VERTICAL
Mirror Bracket
• • •
Bottom edge
of bracket
Bottom Center
Measuring Level
tape
2
HANGING THE MIRROR
□ Use a level on the line marked on the wall to assure the
aluminum mounting bar (AA) is even. Use the mounting bar
(AA) to mark the two outer drill holes.
□ Drill pilot holes in the three marked locations.
□ If you are unable to attach to wall studs, insert dry wall
anchors (BB) into the holes and lightly tap into place with a
hammer.
□
level.
□ Insert and securely tighten the screws (CC).
□ Carefully hang the mirror so the aluminum mounting bracket
on the mirror engages the aluminum mounting bracket (AA)
on the wall and is centered in the desired position.
AA
CC
1002-28-6024
45386
Drill
CC – Screw x 3
Pencil