API 4WW Manual De Instrucciones

PRECAUTIONS
• Never use without the water seal in place:
1. The water seal is the large ring around outer
diameter of unit, located between plastic
dome and plastic base.
• Do not immerse plastic battery/motor
compartment in water.
• Do not allow unit to tip over in birdbath.
• Do not use without metal legs installed.
• Do not allow material such as algae, twigs, or
leaves to become attached to the stirrer, as this
will significantly decrease battery life.
• Always keep water level at least 1/4" below the
plastic base.
• If battery/motor compartment does
become wet:
1. Open unit and remove batteries. Dry
batteries with a towel.
2. Dry battery compartment and motor
using hair dryer.
• Change batteries when unit no longer
creates waves.
• This unit will not keep water from freezing.
Remove the batteries and store the unit during
the winter.
DIRECTIONS
1. Remove the screw
in the top of the
dome to separate the
dome from the base
[figure 1]. Retain the
screw to reattach
dome in Step 5.
Figure 1
2. Insert the 3 "U"
shaped wire
supports into the
base of the unit
[figure 2].
Figure 2
3. Attach the
"stirring device"
to the motor by
pressing into place
using the center
hole in stirring
device [figure 3].
Figure 3
WATER WIGGLER
Item # 4WW, # WBU4WW, # 5WWG-W
4. Now insert the two "D"
cell batteries [figure 4].
The "stirring device" will
begin turning once the
batteries are inserted.
Be sure to insert the
batteries in the direction
indicated on the unit.
5. Close the unit by
reinstalling screw on top
of dome.
6. When the bird bath is filled completely with
water (as will happen after a heavy rain) the
highest water level must remain at least 1/4"
below the plastic bottom of the Water Wiggler.
Figure 5
To determine the depth of your bird bath,
empty the water in the bird bath and place
the Water Wiggler in the deepest portion of
birdbath [figure 5]. Place a yardstick or other
"straightedge" device across the top rim of the
birdbath.
A. If the maximum high-water level (simulated
by the straight-edge placed across the bird
bath) is more than 1/4" from the plastic bottom
of the Water Wiggler, simply place the unit
in the center of your bath and it is ready to
operate.
B. If the maximum high-water level (simulated
by the straight-edge placed across the bird
bath) is less than 1/4" from the plastic bottom
of the Water Wiggler, then you must raise the
unit by placing a stable and level support
under the Water Wiggler. Be sure the unit
is secure and will not fall off of this raised
support.
*Illustrations may not exactly match your unit.
Miller Manufacturing, Glencoe, MN 55336 USA • www.miller-mfg.com
Read Instructions Thoroughly Before Use
Figure 4
REPLACEMENT OF
STIRRING FLOATS
Float replacement (extra floats are located inside
your Water Wiggler).
1. Remove stirrer assembly from the bottom
of the Water Wiggler.
2. Pull the wire guide out of the plastic crossbar.
3. Remove the old floats and place the new floats
on the wire guide (see drawing for orientation).
3. Insert the wire guide back into the crossbar
(center hole faces away from the floats).
4. Make sure the wire guide does not extend
past the top edge of the crossbar, and then
remount the stirrer to the Water Wiggler.
NOTE: The Wire Guide cannot
extend past the Crossbar.
Center Hole
Crossbar
Wire Guide
Float (2)
Note orientation
Stirrer Assembly
302554