ErGear EGESD1 Manual De Instrucciones página 3

Install pedestal(1)
13/64 in.(5x5mm)
Install supporting beam(4)
5/32 x 5/32 in.
(4x4mm)
Loosen
Loosen the preassembled bolts on the
supporting beam (4) using Allen key (C), then
stretch the supporting beam according to the
size of your desktop
Loosen the
preassembled
nut
Stretch the
preassembled
thinner rod and
insert the thinner
rod into the hole
on the left
column (2)
Secure the pedestals (1) to left column (2) and right column (3) using
bolts (A) and Allen key 13/64 in.(5x5mm) (C)
13/64 x 13/64 in.
(5x5mm)
Please adjust the support beam size(4)
according to table top size.
Install supporting beam to the left column
(2) and right column (3) using bolts (B)
and Allen key (C)
Do not exceed one third of the
circle when rotate the angle
Rotate and
insert the other
end of
transmission
rod (5) to the
right column (3)
Tighten the nut
Tighten the
preassembled
bolt
Secure transmission rod (5) to the left
column (2) and right column (3)
02
Keep the pedestal vertical
to the column.
Tighten preassemble bolts on
supporting beam with Allen
key 4x4mm (C)
3/32 x 3/32 in.
(2.5x2.5mm)