DiO VDP-IP01 Guía Rápida página 43

2.3 7'' Screen
3. Mounting the videophone
3.1 Exterior unit
Before you start
• Make sure there is no power supply to the screen.
• Connect the cable for the exterior unit before mounting
• Attach a terminal block to the outdoor unit wires (not included). Please note the size of the
terminal block when drilling the hole in your wall, you will have to pass through it.
A. No flush-mounting
1) Make a space in your wall large enough to fit the protective cover (Dimensional diagram)
2) Insert the pins into the holes and fix the protective cover using the screws provided.
3) Pass the cable through
4) Connect the screen wire to the outdoor unit. Make sure that the 2 units are correctly connected. (Diagram - 2 units)
5) Before attaching the outdoor unit to the protective cover, connect the wires. Refer to the different diagrams and connect the
one that corresponds to your house (Diagram Lock + Gates - 2 Gates - 2 Lock)
6) Use the screws provided to fix the exterior unit to the protective cover
B. Flush mounting
2
3
1
1 Microphone
2 24 V supply connector
3 Exterior unit connector
4 Speaker
4
Caution, do not remove the connectors
(cables 2-3) from the display, as this may
break them and damage the product.
1) Make a space in your wall large enough to fit the flush-
mounting box
2) Make 4 holes in line with the position show on the flush-
mounting box (Dimensional diagram)
3) Insert the pins into the holes and fix the flush-mounting box
using the screws provided.
4) Pass the cable through
5) Connect the screen wire to the outdoor unit. Make sure that
the 2 units are correctly connected. (Diagram - 2 units)
6) Before attaching the outdoor unit to the flush-mounting box,
connect the wires. Refer to the different diagrams and connect
the one that corresponds to your house (Diagram Lock +
Gates - 2 Gates - 2 Lock)
7) Use the screws provided to fix the exterior unit to the flush-
mounting box