Scosche GOBAT 2600 Guia Del Usuario

GOBAT 2600
3-IN-1 POWER BANK,
CAR CHARGER & FLASHLIGHT
CONTENTS / FEATURES
A B C D
G
A USB Output
B Micro USB Input
C LED Battery Level Indicator
D Power Button
E 12V Charge Plug
(for Power Bank)
F Protective Cover with Magnetic Mounting Option
G LED Flashlight
H USB to Micro-USB Charge Cable
Questions?
Need help with your Product?
Call Customer Service at:
(800) 363-4490 x1
Register your product online at
©2019 SCOSCHE INDUSTRIES, INC.
TM
E
F
H
SPECIFICATIONS
Input 1 (Car Socket): 12-16VDC
Input 2 (Micro-USB): 5V
Output: 5VDC 1.5A
Battery Capacity: 2600mAh
www.scosche.com/register
SI 300PBC71 (ENGLISH) 5/19
PBC71
1
(A) Use the included charge cable to connect to a USB power source (not included) OR
(B) Plug the power bank into your vehicle's 12V auxiliary socket.
2 To activate backup power for your
device, press the power button on
the power bank. You may push the
button at any time to check battery
level. The LED indicator shows 25,
50, 75, and 100% charge levels, and
flashes in sequence while charging.
3 To use the power bank as a flashlight, press and hold the power button for 3 seconds.
When on, press the power button once to change to the safety strobe. To
turn off the flashlight function, press and hold for 3 seconds.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
0.5A
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
1A
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement: The product complies with the FCC/IC RF Exposure for Low Power Consumer Wireless Power
Transfer. RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this
manual. The further RF exposure that compliance was demonstrated at 10cm and greater separation from the user body or set
the device to lower output power if such function is available.
This device complies with Industry Canada's license-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
The term "IC:" before the certification/registration number only signifies that the Industry Canada technical specifications were
met. This product meets the applicable Industry Canada technical specifications.
For complete warranty details, please visit us at www.scosche.com or call (800) 363-4490
USER GUIDE
FCC STATEMENT
IC STATEMENT