Home Depot OMSID 204294436 Manual De Instrucciones página 6

INSTALLATION & ASSEMBLY (cont.):
5. Place the Wall Plate (#10) over the Outlet Box (#4) and onto the Fixture
Mounting Screws (#6), and adjust the Fixture Mounting Screws (#6) until
they protrude out from the Wall Plate (#10) 1/4". Remove the Wall Plate
(#10) and secure the position of the Fixture Mounting Screws (#6) by
tightening the Hex Nuts (#9) against the Mounting Bracket (#7). Place the
Wall Plate (#10) back onto the Fixture Mounting Screws (#6), and secure it
into place using the Lock Nuts (#3) provided.
6. After installing the fixture, caulk the upper
2/3s of the Wall Plate (#10) to mounting
surface. Leave the bottom 1/3 un-caulked
for drainage of any water that might leak
drainage of any water that might leak into
the enclosure.
recommends a non-drying exterior caulking
material. A good example is a clear silicone
rubber sealant for exterior use.
7. Install up to a 100 watt Light Bulb (#2) or
Listed SBCFL (Self-Ballasted Compact
Fluorescent Lamp [not provided]) in the
socket of the Main Fixture Body (#1). Do
not exceed a 100 watt incandescent light
bulb, or a 26 watt SBCFL.
8. Attach the Cage to the Main Fixture Body
using the provided Cage Screws.
9. Installation is complete. Turn on power at
the circuit breaker or fuse box. Turn the
light switch on to activate the fixture.
The manufacturer
Fig. 2
Page 6