Control Panel; Filter Replacement; Replacing Filters - Uline H-8650 Guia De Inicio Rapido

1. Power – To turn on or off, press power button.
2. Fan Speed – Select low, medium or high by pressing
power button until desired speed is illuminated.
NOTE: Dust and allergens are most often
airborne when people and pets are active
in room. For best results, set unit on a higher
speed setting during these times for high
demand cleaning and circulation. Set unit
to a lower setting for quieter operation when
activity is reduced.
3. Carbon Filter Replacement – Replace Carbon filter
indicator light shows when it is recommended to
change carbon filter. Refer to Filter Replacement
below. This feature is controlled by time of use. The
light will illuminate after 4,000 hours of run time.

REPLACING FILTERS

1. Unplug unit.
2. Remove front panel by lifting up and away from unit.
(See Figure 1)
Figure 1
NOTE: Front panel is held in place by magnets.
Lift front panel hard enough to overpower
resistance of magnets.
PAGE 2 OF 12

CONTROL PANEL

2 1
4. HEPA Filter Replacement – Replace HEPA filter

FILTER REPLACEMENT

3. Remove the plastic filter frame by pulling on the
3 4
indicator light shows when it is recommended
to change the HEPA filter. Please refer to Filter
Replacement instructions below. This feature is
controlled by time of use. The light will illuminate
after 9,000 hours of run time.
NOTE: User environments will differ. Filter
replacement time is based on average use
situations. If using air cleaner in a more
demanding environment, changing filter more
frequently may be necessary. In less polluted
environments, filter life may extend beyond
the notification.
center tabs. Flexing the plastic filter frame slightly
may be necessary to release the tabs at the top
and bottom. (See Figure 2)
Figure 2
Center
Tab
0721 IH-8650