Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
F
1
G
E
F
1
A
H
I
F
J
1.
Insert new floor bolts (F) into the slots on the toilet flange (1) (not
included) with the bolt heads down and threaded ends facing up.
Use plastic retaining washers (G) to hold the bolts (E) in a full-length,
upright position.
2.
Floor bolts (F) should be parallel to the wall and 6 in. apart.
1.
Turn the toilet (A) on it's side onto a towel or cushioned surface.
A
2.
With the rounded (tapered) end of the ring facing the toilet, place
the wax ring (E) around the raised outlet ring of the base (A), and
press firmly enough so the wax ring (E) adheres to the base (A).
Lower the toilet (A) onto the oor bolts (F) so the bolts project through the
1.
mounting holes in base of toilet (A).
2.
Using a rocking motion, press the bowl down to position the toilet onto the
A
flange (1).
3.
Once the toilet (A) is in position, press down with a slight twisting motion on
the top center of the bowl (A) and eventually apply full body weight to evenly
compress the wax ring (E). This creates a water-tight seal.
IMPORTANT: The toilet (A) should be firmly seated on the floor, so it
does not wobble or rock.
CAUTION
Do not rock the bowl back-and-forth, as this may break the seal.
1.
Place the metal washers (I), and hex nuts (H) on the floor bolts (F).
Alternately tighten the nuts (H) until the toilet (A) is firmly seated on
the floor.
2.
Pour water into the toilet bowl (A) to prevent the escape of sewer gases.
3.
Place the side caps (J) on the toilet (A) and press in for a secure t.
CAUTION
Do not overtighten the hex nuts (H), as vitreous china can easily
crack or chip.
PAGE 4
2-Piece High Efficiency Toilet
Installation Instructions
Publicidad
Tabla de contenido
