Failure Display And Inspection; Technical Specification - GIONIEN GIT230SP Manual De Instrucciones

Failure Display and Inspection

If an abnormality comes up,the induction hob will enter the protective state
automatically and display corresponding protective codes:
Error
Message
No pot or pot not suitable;
Water or pot on the glass over the control
ER03
The connection between the display board and the
mainboard is fail (the cooking zone which indicator
F1E
showing "E")
Coil temperature sensor failure. (the cooking zone
F3E
which indicator showing "E")
Mainboard temperature sensor failure. (the cooking
F4E
zone which indicator showing "E")
Temperature sensor of the ceramic glass plate is
E1E
high
Temperature sensor of the IGBT is high
E2 E
Abnormal supply voltage(too high)
E3 E
Abnormal supply voltage (too low)
E4 E
Temperature sensor failure(the cooking zone which
E5 E
indicator showing "E")
The above are the judgment and inspection of common failures.Please do not
disassemble the unit by yourself to avoid any dangers and damages to the
ceramic hob and please contact the supplier.

Technical Specification

Cooking Hob
Cooking Zones
Supply Voltage
Installed Electric Power
Product Size L×W×H(mm)
Building-in Dimensions A×B (mm)
Weight and Dimensions are approximate.Because we continually strive to
improve our products we may change specifications and designs without prior
notice.
Possible Cause
15
What to do
Replace the pot;
Clean the user interface
Connection cable not correctly plugged or
defective;Replace the mainboard or power .
Replace the coil sensor
Replace the mainboard
Please restart after the induction hob cools
down.
Please restart after the induction hob cools
down.
Please inspect whether power supply is normal;
Power on after the power supply is normal.
Please inspect whether power supply is normal;
Power on after the power supply is normal.
Connection cable not correctly plugged or
assemble defective;
GIT230SP/GITS352G3
2 Zones
220-240V~
2800W/3500W
290X520X70
265X495