Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
13733
Programming Instructions
Disclaimer: All currently programmed and new remotes must be reprogrammed to vehicle. Please have in
hand at time of programming.
1.
Close all vehicle doors.
2.
Insert the key into the ignition.
3.
Hold down the power UNLOCK button on the driver's door panel-continue to holddown until
instructed to release in step 9.
4.
Perform steps 5 through 8 in fairly rapid succession.
5.
Turn the ignition switch to the ON position (as far as you can go without starting the engine).
6.
Turn the ignition switch to the OFF position.
7.
Turn the ignition switch to the ON position.
8.
Turn the ignition switch to the OFF position.
9.
Release the power unlock button on the door panel. The vehicle will lock and unlock the doors
automatically.
10.
Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until the door locks and
unlocks. This step may take up to 30 seconds.
11.
Repeat step 10 NOW for each additional transmitter (including any existing transmitters).
12.
Turn the ignition switch to the ON position in order to exit the transmitter programming mode.
1
Publicidad
Manuales relacionados para Dorman 13733
Resumen de contenidos para Dorman 13733
- Página 1 13733 Programming Instructions Disclaimer: All currently programmed and new remotes must be reprogrammed to vehicle. Please have in hand at time of programming. Close all vehicle doors. Insert the key into the ignition. Hold down the power UNLOCK button on the driver’s door panel-continue to holddown until instructed to release in step 9.
- Página 2 Instrucciones de Programación Descargo de Responsabilidad: Todos los controles remotos actualmente programados y nuevos deben ser programados al vehículo. Por favor tenerlos a mano a la hora de la programación. Cierre todas las puertas el vehículo. Inserte la llave en la ignición. Mantenga presionado el botón UNLOCK del panel de la puerta del conductor, siga presionándolo hasta que se le indique en el paso 9.
- Página 3 Instructions de Programmation AVERTISSEMENT : Toutes les télécommandes actuellement planifiées et nouvelles doivent être programmés pour le véhicule. S'il vous plaît garder très pratique quand il s'agit de programmation. Fermez toutes les portes du véhicule. Insérez la clef dans le contacteur d’allumage. Appuyez et maintenez le bouton DÉVERROUILLER «...