Quick Setup - Aqara SJCGQ11LM Manual De Usuario

Quick Setup

1. Before activating the accessory, please make sure you have
the Aqara Home app downloaded and Aqara hub installed.
2. Please open the app, tap "Home" and then tap "+" in the top
right corner to enter "Add Device (Accessory)" page. Select
"Water Leak Sensor", and add it according to
instructions.
* If the connection fails, please move the accessory closer to the Hub
and try again.
Installation
E ective Range Test: Single press the reset button on the
accessory at your desired position. If the Hub makes voice
prompts, it indicates that the accessory can communicate
e ectively with the Hub.
* Avoid metal surface to maximize signal strength.
Option 1: Place it directly on the surface where you need
to monitor water leak.