Feiss P1297 Manual Del Usuario

Installation Instructions for
Dutch 1 Light Pendant
Pendant
G ENERAL RODUCT NFORMATION P
These fixtures are intended to be installed utilizing NEC compliant
junction boxes.
This product is safety listed for dry locations only.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
1A
CORD CLIP
CLIP SCREW
CORD
Determine the wanted height of the fixture by feeding the cord through the canopy and moving the cord up or down.
1
Place the cord in between the two cord clips and secure it in place using the clip screws.
2
3 Trim the cord leaving enough for electrical connections. From the end of the cord, strip the insulation 4" and then strip the
end of the wires. Note: Make sure not to nick the inner wires.
Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.
4
5 Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
I :
2
CANOPY
FIXTURE
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
4
LAMP
5
1
P1297-P1298-P1316
P1297, P1298, P1316
1.1