Worx LEAFPRO WA4054.2 Guia De Inicio Rapido página 6

open the vacuum cover. A slot will appear at
the joint of the vacuum cover and machine.
Then Attach the TURBINE FUSION
to the slot as shown in Step 2 of A2. Align
the arrow, on the Collection System adapter,
to the smaller Locking Peg on the TURBINE
FUSION adapter outlet. Then slide the
TM
Collection System adapter over the aligned
Locking Pegs and turn clockwise to lock,
ensuring they are fully secured. No additional
adapter is needed. (See Step 3 of A2).
To remove the Universal Collection System,
simply reverse the installation steps.
CAUTION!
- Avoid Dangerous Environment: It is NOT
RECOMMENDED to vacuum damp or wet
leaves.
- Do not vacuum solid objects such as
carpentry wood blocks, large branches, broken
glass, or pieces of metal and stones.
SECTION 3
Assembly: WORX Brand WG512, WG513,
WG514 Model – LEAFPRO
6
WG513, WG514 collection system (Refer
to A3)
To assemble LEAFPRO
WG514 adapter,
Fit the adapter for TRIVAC
WG513, WG514) onto the collection system
Hose Inlet and then attached the system on
the machine as shown in A3.
Before operation, flip the blow/vac switch into
the vacuum mode.
To remove the Universal Collection System,
simply reverse the installation steps.
SECTION 4
Assembly: All Brand Models - Universal
Collection System
All Brand Models – Choose the "Universal
Fit" adapter (5) and place it onto the Vacuum
Outlet. Please refer to B1-B5.
1. Place the fabric side of the Universal
Adapter over the Vacuum Outlet and slide it on
as far as possible (B1)
2. Pull to tighten the strap and snap the latch
down (B2)
LEAFPRO™
adapter
TM
for WG512,
TM
for WG512, WG513,
TM
models (WG512,
TM
3. Test that the Universal Adapter will not slide
off of the blower/vac outlet
4. If further tightening is needed, then unlatch
the latch button and tighten the strap to
further lock the Universal Adapter. Press the
latch down again and recheck if it will slide
off of the blower/vac outlet (B3). Realign and
repeat these steps if needed.
5. Slide the Collection System adapter over
the aligned Locking Pegs and turn clockwise
to lock, ensure they are fully secured (Please
refer to B5).
Please note: The Universal Adapter may
have space between the Vacuum Outlet and
Adapter Outlet after installation.
To remove the adapter, simply unlatch and
loosen the strap to remove it from the Vacuum
Outlet (Reverse B4).
SECTION 5
Assembly: Container Installation -
LEAFPRO™ Universal Collection
(See Fig. C, D, E)
SECTION 6
Assembly: Troubleshooting
NOTE: If you are having a hard time keeping
the cover on the trash can, please try the
following: Cut a notch between the handle and
trash can rim to create a grove for the
cover to rest in.
EN