Charging The Battery; Tool Set Up - CEN-TECH 60695 Manual Del Propietário

Charging the Battery

1. Plug the Power Supply into the DC
Power Input, then plug other end
into a grounded 120V outlet.
2. The red Charging Indicator will
come on and will turn green
when charging is finished.

Tool Set Up

TO PREVENT SERIOUS INJURY FROM ELECTRICAL SHOCK:
Make sure that the Camera is OFF and unplugged from its
charger before performing any procedure in this section.
Connecting Cable:
1.
a. Carefully push Cable's key
into Cable Connector's slot.
b. Turn Cable Connector
counterclockwise until the
Cable and Cable Connector
are securely attached.
2. Disconnecting Cable:
a. Turn Cable Connector clockwise
until the Cable and Cable
Connector are detached.
b. Remove Cable.
Slot
Cable
Connector
3. Micro SD Card
a. Insert a Micro SD Card
(sold separately) into the Memory
Card Slot, then push down on the
card until it clicks into place.
Item 60695
Key
Cable
Figure A
For technical questions, please call 1-888-866-5797.
3. DO NOT charge longer than
recommended.
(See "Specifications" on page 4.)
4. When charging is complete, disconnect
Camera from Power Supply, then
unplug Power Supply from outlet.
Note: When the card is installed, the
icon will appear on the Display Screen.
b. To remove card, push down on the
card until it pops up, then remove.
4. Attaching Accessories:
a. Carefully slide the accessory
onto the Imager Head.
b. To remove accessory, carefully slide
the accessory off the Imager Head.
Imager
Head
Figure B
5. Connecting to Computer with
USB to Mini-B Cable:
Plug the Mini-B end into the Mini-B Port,
then plug the USB end into a computer.
6. Connecting to External
Monitor with RCA Cable:
Plug one end into the RCA Video
Out Port, then plug other end into
RCA Video In port on monitor.
Accessory
SD
Page 7