Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL THE JADE HEAT PAD
1. Open the backrest pad zipper, then lift the right-hand side of the foam out of the backrest pad cavity
and flip it to the left. CAUTION: Do not completely remove the foam or you will disconnect or damage
the lumbar air valve on the left-hand side). (Fig.2)
2. Remove the protective strips covering the hook-and-loop fastener strips at the top and bottom of the
backrest pad cavity.
3. Insert the jade heat pad into the backrest pad cavity, aligning the hook-and-look fasteners on the
underside of the pad with the corresponding fasteners on the inside of the backrest pad, then smooth
it until it is flat (Fig.3).
4. Thread the jade heat pad cable through the hole in the backrest upholstery.
Backrest foam
Fig.2
5. Reinstall the backrest pad foam into the backrest pad cavity, on top of the jade heat pad.
6. Smooth the foam inside the pad, pulling it firmly toward the pad edges. HINT: Begin with the top
corners then work your way down the sides (Fig.4).
7. Close the backrest pad zipper (Fig.5).
Fig.5
2
Jade heat pad
Fig.3
Backrest foam
Jade heat pad
Fig.4
INSTALL THE POWER HUB
1. Gently turn the chair onto its left-hand side (Fig.6).
2. Locate the four screw holes on the bottom of the front cross bar (Fig.7).
3. Using a Phillips-head screwdriver, secure the power hub to the chair with the cord facing upward,
using the four provided screws (Fig.8).
4. Leaving approximately two feet of the chair power cord, coil the excess cord neatly (Fig.9).
5. Open the pocket on the bottom of the chair canvas, then tuck the coiled cord into the lower pocket (Fig.9).
Fig.6
logo facing up
Power hub
Fig.8
6. Plug the chair power cord into the power hub (Fig.10).
7. Plug the transformer into the power hub outlet (Fig.10).
8. Feed the transformer plug up through the hole in the chair canvas (Fig.11).
9. Gently return the chair to the upright position.
Chair power cord
Front cross bar
Coiled
power cord
Fig.9
Transformer
Transformer plug
Fig.10
Front cross bar
Fig.7
Transformer plug
Fig.11
3
Publicidad
