Peavey Auto-Tune AT-200 Manual Del Propietário página 9

ThE GuITAR CONTROls
1. Volume + string Tune
®
In both active Auto-Tune mode and pas-
sive mode (using the normal humbucking
pickups), this knob controls the volume of
the instrument. This knob also includes
the momentary switch that triggers the
String Tune function.
2. Pickup selector
The pickup selector switch selects be-
tween neck pickup, both pickups and
bridge pickup tones.
3. Master Tone + Active/Passive Mode
When this knob is in the normal "down"
position, the Auto-Tune active mode is
turned on (unless the cable is unplugged).
When this knob is pulled up, the Auto-
Tune system is turned off and the guitar
operates in normal, passive mode. This
will prove to be very handy if you run out
of battery life during a performance. In
both Active and Passive modes, this knob
also serves as the master Tone control.
PeAvey usA DesIGN humBuCkers
5
BATTery Box
on back of guitar
4
JACk PlATe
1/4" output
8-pin DIN in/out
3
ToNe CoNTrol
Pot down: Tone control for AT-200 Audio out.
Pot up: Turns off power to AT-200 board and selects passive
pickup output. Passive tone control in this position.
6
2
3-wAy PICkuP seleCTor swITCh
7
leD INDICATor
1
volume/AuTo-TuNe CoNTrol
Pressing engages string Tune and turns on solid-Tune
™
.