Buffalo GD220 Manual Del Usuario página 4

Operation
Loading a Towel Roll
Insert the plastic towel roll rods (1) into the central hole of the towel roll. Open the upper cover (3)
and place the towel roll into the machine.
Lift the towel pressing cover (5) and flatly insert the end of the towel roll into the roller (6). Release
the towel pressing cover back into position.
Please note: The end of the towel roll should be dry and flat.
Loading the Water Tank
Fill the water tank (4) with water and tighten screw cap.
Place the water tank upside-down into the machine.
You may add disinfectant or essence into the water tank according to needs.
Opening the Towel Plate
Press 'PUSH' to open the towel plate (10).
Switching on Power and Starting Up
Press the power switch (9).
The green indicator on the display panel will light, the buzzer will 'beep' once and the LED display will show
'01'
Setting Towel Quantity
The Buffalo Wet Towel Dispenser can be set for up to 18 towels per cycle.
Press the 'quantity' key on the control panel (8). Each press of the quantity key will cycle through
the quantity's 1-18.
Dispensing Wet Towels
Press the 'start/stop' key. The machine will dispense hot or cold wet towels at the preset quantity.
When the preset quantity of towels is completed, the LED display will return to display the set towel
quantity.
Note: Pressing the 'start/stop' key when towels are being dispensed will stop the machine and cancel the
dispensing operation.
If towels fail to come out smoothly, please stop the machine immediately by switching off the power.
Open the upper cover, lift the towel-pressing cover and pull out the curled or seized towel. Remove any
frayed or damaged ends from the towel roll and reload the towel roll before restarting the machine.
Telephone Helpline: 0845 146 2887 (United Kingdom)