Steren LAM-507 Manual De Instrucciones página 16

Installation and use
1.- Take out the power connector using
the button on the top and connect the
lamp to a power outlet.
2.- The charge LED lights on. The fist
time you connect the lamp, please
remain it connected for at least 12
hours to reach the maximum capacity.
3.- To make a test follow the next steps:
Select the 10 LEDs mode (in the 1 LED
mode the lamp will not turn on when
there's an outage).
After 5 minutes, unplug the lamp from
the outlet, simulating an electrical fail.
The lamp turns on automatically.
Connect the lamp again.
6