allen+roth ALC02917 Manual De Instrucciones página 4

ASSEMBLY INSTRUCTIONS
1. Place the table rim (A) upside down on a flat,
non-abrasive surface. Attach a table leg (C) to
the table rim (A) by using the 1/4 in. x 20 mm
bolts (BB) and washers (CC). Guide the bolt
(BB) through the hole in the table leg (C) and
into the pre-drilled hole in the table rim (A). Hand
tighten 2-3 revolutions only. Repeat for the other
three legs. Attach the topside supports (H) to the
table rim (A) using the same procedure.
Hardware Used
BB 1/4 in. x 20 mm Bolt
CC Ø 6.5 x 1.0 mm Washer
2. Attach the leg connector bracket (B) to the legs
(C) by using the 1/4 in. x 28 mm bolts (AA)
through the holes in the leg connector bracket
(B). Add a washer (CC) to the end of each bolt
(AA). Hand tighten 3-4 revolutions only. Do not
tighten completely. Repeat on the other three
legs. Then, attach the topside supports (H) to
the connector bracket (B). Guide the bolt
through the hole in the table leg (C) and into the
pre-drilled hole in the leg connector bracket (B).
Hardware Used
1/4 in. x 28 mm Bolt
AA
Ø 6.5 x 1.0 mm Washer
CC
3. Tighten bolts (AA and BB) using the hex bolt
driver (EE). Important note: Tighten each bolt a
few revolutions at a time. We recommend
working in a cross corner fashion, alternating
between bolts. This will tighten the frame evenly
by placing equal pressure on all bolt joints. Do
not overtighten. Cover all bolts with covers (DD)
provided. With the help of another person,
carefully turn the table in the upright position.
Put the tiles (D, E, F and G) inside the table rim.
Your table is now ready for use.
Hardware Used
Ø 1/4 x 14 mm Cover
DD
1
x 4
x 4
2
x 8
x 8
3
x 4
4
Lowes.com/allenandroth