NOTE: We recommend using Bemis by Essick Air Bacteriostat #1970 treatment when you refill the tank to eliminate bacterial growth.
Add bacteriostat according to the instructions on the bottle and then tighten the bottle cap on your water bottle.
NOTE: Overfilling will result in water damage.
OPERATION
1)
Plug cord into wall receptacle. Your humidifier is now ready for use. The
humidifier should be placed at least FOUR inches away from any walls and
away from heat registers. Unrestricted airflow into the unit will result in the
best efficiency and performance.
2)
The digital control allows you to use the low setting for the quietest operation
or a high setting for maximum output.
3)
For initial operation, push the speed button once for the sleep setting and
continuously press the button to increase desired speed. TO STOP the unit,
press the speed button for two seconds, or keep pressing button until
display reads OFF.
4)
To take advantage of the digital humidistat, press the speed button to any
setting other than OFF. Then adjust the set humidity by using the up and
down buttons. Humidity will increase in increments of 5%. When the room
humidity level rises above the set humidity, the humidifier will stop. When
the humidity level drops below the set humidity, the humidifier will turn on
automatically.
5)
The refill light will indicate when the unit is completely out of water in both bottles. The motor will also shut off. To refill, refer
back to Step 4 – Important Filling Information.
NOTE: When excessive condensation exists, a lower speed setting is recommended.
CAUTION: Disconnect power before filling, cleaning or servicing unit. Keep grille dry at all times.
CARE AND MAINTENANCE
Cleaning your humidifier regularly helps eliminate odors and bacterial and fungal growth. Ordinary household bleach is a
good disinfectant and can be used to wipe out the humidifier base and reservoir after cleaning.
We recommend cleaning your humidifier at least once every two weeks to maintain optimum environmental conditions for your
home.
We also recommend using Essick Air Bacteriostat Treatment each time you refill your humidifier to eliminate bacterial
growth. Add bacteriostat according to the instructions on the bottle. Please call 1-800-547-3888 to order Bacteriostat Treatment
reference part#1970.
1)
Turn off unit completely and unplug from outlet.
2)
Carry base and bottles to cleaning basin and remove bottles.
3)
Lift wick from the base allowing the water to drain. Rinse wicks under freshwater only. Do not use soap, detergent, or any other
cleaners on the wick. Leave in sink to drain.
REMOVING SCALE
4)
Empty the water from the reservoir and bottles. Fill bottles and reservoir ½ full with water and add 8 oz. (1 cup) of undiluted
vinegar to each. Let stand 20 minutes. Then empty solution.
5)
Dampen a soft cloth with undiluted white vinegar and wipe out reservoir to remove scale. Rinse the reservoir thoroughly with
fresh water to remove scale and cleaning solution before disinfecting.
DISINFECTING UNIT
6)
Fill the bottles and reservoir ½ full with water and add 1 teaspoon of bleach to each container. Wet all surfaces on cabinet, then
let solution stay for 20 minutes then rinse with water until bleach smell is gone. Dry with clean cloth. The outside of the unit may
be wiped down with a soft cloth dampened with fresh water.
7)
Refill unit and re-assemble per ASSEMBLY instructions.
SUMMER STORAGE
1)
Clean unit as outlined in Care & Maintenance section.
2)
Discard used wick and any water in the reservoir and allow unit to dry thoroughly before storage. Do not store with water inside
bottles or reservoir.
3)
Do not store unit in an attic or other high-temperature area.
4)
Install new filters at beginning of season.
3