Weather Guard 9444-3-01 Manual De Instalación página 3

STEP 3: Two (2) Mounting Straps and
Mounting Strap Angles are provided. The
Mounting Straps can be bent to any shape
and/or used with the Mounting Angles. The
Mounting Straps should be attached to the
upper portion of any product mounted on
top of this Cabinet in a manner that would
minimize movement of the unit both front to
rear and side to side. Attach the Mounting
Straps to the unit through existing holes (or
drill new holes using a 5/16" drill bit) and
fasten with 1/4-20 x 5/8" Hex Head Bolts,
1/4" Flat Washers and 1/4-20 Nylon Lock
Nuts.
Fasten the other end of the Mounting Straps by
installing two (2) Blind Fasteners in the wall or wall
ribs at the Mounting Strap locations by pre-drilling
1/8" holes and then re-drill the holes with a 13/32"
drill bit. Set the Blind Fasteners in the holes per
the INSTALLATION INSTRUCTIONS FOR BLIND
FASTENERS below.
Realign the Mounting Straps/Mounting Strap
Angles on top of the Blind Fasteners and secure
them to the wall or wall rib using two (2) 1/4-20 x
3/4" Hex Head Bolts and 1/4" Lock Washers.
NOTE: If no product is mounted to the top of the
unit, the unit must be attached to the wall.
INSTALLATION IS NOW COMPLETE.
INSTALLATION INSTRUCTIONS FOR BLIND FASTENERS
Place a drop of oil on the black oxide bolt before
assembling as shown on right. Place the Blind Fastener in the
hole and use a 7/16" wrench to tighten black hex bolt until the
Blind Fastener is fully seated. When setting black hex bolt, it will
start out hard. As the Blind Fastener "bulbs" out it will get easier,
until it bottoms out or sets. Make sure the Blind Fastener and
Installation Tool do not turn during installation.
7/16" Wrench
(Or 7/16" Socket)
Black Oxide Bolt
9/16" Wrench
Installation Tool
Blind Fastener
3
Flat Washer