Charging Method - Aigostar 8433325185770 Manual De Instrucciones

GB
CUTTING SIZE ADJUSTMENT
Choose the suitable comb size
as you need
Choose the
suitable comb
size as you need

CHARGING METHOD

Put the adaptor connector terminal into the product.

Make sure the product is in the position of Power Off

and then put the plug into the socket. The LED light in
product will show in red color. As soon as it is fully charged,
the LED light will turn into blue color and start flashing.
Charging time is around 2.5 hours.

CHARGING NOTICES
Notes: If the product not being used for a long time, please ensure the

battery charged at least one time within 3 months to avoid damage.
Plug-and-play function means that you can use the product while
charging in case of insufficient power.
Put the adaptor connector terminal into the port of the product and

then plug into a socket. Switch on the product and then use it.
 After using, switch off and then disconnect the adaptor connector with
product.
If the battery has been used out, it may be difficult to start the

05
Take out the comb
Take it out by pushing both sides of
comb by your thumbs
DIRECT CHARGING
Don't take the
adaptor out from
the socket by wet
hands to avoid the
risk of electric
Warning!
shock.
The using methods while Plug-and-play:
product even if it is plugged. You should restart it after charging at least one or two
minutes. While charging, the product body and the adaptor may be a little hot,
however, it is a normal phenomenon.
Take the adaptor out from the power socket

Take the plug out from the product, please hold the plug and take it out.

Don't pull the cord in order to avoid any damage for adaptor.
Don't charge the product more than 6 hours each time.

THE CUTTING HEAD DISASSEMBLING & ASSEMBLING
Cutting head disassembling
Use another hand
to hold the
cutting hear to
prevent it flying
out.
Cutting head assembling
1. Insert A into B.
2. Turn the control knob into
the position of 2.0mm
3. Press it until a click sound.
GB
06