StarTech.com WALLMOUNTH1 Guia De Inicio Rapido

1U 19in Steel Hinged Wall Mount Bracket for Patch Panels
Product Diagram (WALLMOUNTH1)
1
2
Component
1 Mounting Holes (4)
2
Hinged Side Panel
Equipment Mounting
3
Holes
Requirements
For the latest requirements, please visit
Phillips Head Screwdriver x 1
•
(Optional) Cage Nut Tool x 1
•
Installing the Wall Mount Bracket
Warnings: If you lack the necessary expertise to attach this product to the wall, consult a
professional to install the Wall Mount Bracket or to provide specific mounting instructions
for your wall structure.
Make sure that the type of wall structure and mounting hardware that you are using will
properly support the mounted equipment. Failure to do so might result in personal injury
and/or equipment damage. The wall structure should be capable of supporting at least
four times the weight of the mounted equipment.
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.
Function
Used to mount the Wall Mount Bracket to a
•
Wall.
Maximum weight capacity = 8 kg (17 lb).
•
Used to access the back of the installed Patch
•
Panel.
Used to mount a Patch Panel in the Wall Mount
•
Bracket.
Maximum height = 1U.
•
www.startech.com/WALLMOUNTH1
Installing a Patch Panel into the Wall Mount Bracket
Note: Do not add equipment to the Wall Mount Bracket until it is securely attached
to the wall.
Insert the one end of the M6 Cage Nut (included) into the Equipment Mounting
1.
Hole. Push the other end of the M6 Cage Nut into the Equipment Mounting Hole,
until you hear it snap (lock) into place.
Note: It is recommend that you use a Cage Nut Tool (sold separately) to aid with the
installation of the Cage Nuts.
3
Repeat step 1 to install the remain M6 Cage Nut (2 per side) into the Wall Mount
2.
Bracket.
Line up the Mounting Holes on the Patch Panel with the M6 Cage Nuts on the side
3.
of the Wall Mount Bracket with the Hinged Side Panel.
Insert 2 M6 Screws (included) through the Mounting Holes on the Patch Panel and
4.
into the M6 Cage Nuts.
Connect any required Cables to the back of the Patch Panel.
5.
Line up the Mounting Holes on the other side of the Patch Panel with the M6 Cage
6.
Nuts.
Insert 2 M6 Screws through the Mounting Holes on the Patch Panel and into the
7.
M6 Cage Nuts.
Using a Phillips Head Screwdriver (sold separately) tighten the M6 Screws.
8.
Accessing the Back of a Patch Panel
While supporting the weight of the Patch Panel, use a Phillips Head Screwdriver
1.
to unscrew two M6 Screws from the Cage Nuts, leaving the other two M6 Screws
attached to the side of the Wall Mount Bracket with the Hinged Side Panel.
Note: Make sure that there is enough clearance for the Patch Panel to free swing
away from the Wall Mount Bracket, before accessing the back of the Patch Panel.
Gently swing the Patch Panel away from the Wall Mount Bracket to gain access to
2.
the back of the Patch Panel.
Reattach the two M6 Screws removed in step 1.
3.
Quick-Start Guide
Manual Revision: March 24, 2020 4:09 PM