Harman AKG CU800 Guia De Inicio Rapido página 2

Error
EN
All LEDs dark.
All LEDs dark although at least one charging
slot is loaded.
STATUS LED flashing red.
The remaining battery life time on the
display of the transmitter shows a
question mark.
Possible cause
No defect. STATUS LEDs are not activated
before you insert a transmitter with batteries
into a charging slot.
1. AC adapter is not connected to power.
2. DC cable is no not connected to charger.
3. One or more charging contacts fail to make
contact with the transmitter.
4. Internal error.
Charging cycle has been stopped:
1. Transmitter uses dry batteries.
2. Charging contacts contaminated.
3. Inside temperature of batteries is too high.
4. Inside temperature of charger is too high.
5. Batteries defective (voltage <0.5 V).
6. Charger connected to incompatible power
supply whose output voltage is too high: both
STATUS LEDs flashing red.
7. Charger defective.
The transmitter cannot detect the charge
status of
1. the dry batteries.
2. the rechargeable batteries.
Correction
1. Connect power supply to convenient power
outlet.
2. Connect DC cable to charger.
3. Check contacts for resilience, or clean
contacts.
4. Disconnect power supply or DC cable,
wait for 10 seconds, and connect again.
Should the problem persist, contact your
nearest AKG Service Center.
1. Remove transmitter from charging slot;
replace dry with rechargeable batteries.
2. Clean charging contacts on charger and
transmitter with soft cloth.
3. Allow batteries/charger to cool down,
charging cycle will resume when temperature
returns to acceptable range. Should the
problem persist, contact your nearest AKG
Service Center.
4. Make sure there is enough free space
around charger to provide adequate heat
dissipation.
5. Replace batteries.
6. Use original AC adapter supplied with
charger.
7. Contact your nearest AKG Service
Center.
1. Insert new batteries.
2. Fully charge the rechargeable batteries.