Important Safeguard; Description Of The Appliance - DeLonghi D34528 DZ Manual Del Usuario

IF THE DEEP FRYER HAS A CORD WITH MAGNETIC CONNECTOR
First, connect the magnetic connector to the
appliance as shown in figure 8, making sure the
protruding part of the connector (X) is correctly
inserted into the corresponding outlet on the
appliance. Then plug the cord into the outlet.
Warning
Never leave the appliance plugged into the outlet if
the magnetic connector is not fitted to the deep

IMPORTANT SAFEGUARD

A DEEP FRYER FALLING FROM A HIGH PLACE
MAY CAUSE SERIOUS BURNS. NEVER LEAVE THE
CORD HANGING FROM THE EDGE OF THE SUR-
FACE THE DEEP FRYER IS RESTING ON WHERE IT
COULD BE GRASPED BY A CHILD OR GET IN THE
WAY OF THE USER. DO NOT USE EXTENSION
CORDS.

DESCRIPTION OF THE APPLIANCE

A. Display
B. "-/+" buttons to increase/decrease time and
temperature
C. MODE button to select time/temperature modes
D. START/STOP button
E. Red POWER on light
F. Green "at temperature" READY light
G. LF button to melt the lard + counter reset
H. Safety micro-switch
Basket with folding handle
I.
J. Maximum food quantity indicator
K. Removable bowl
L. Oil MIN-MAX levels
THERMAL SAFETY DEVICE
The appliance is fitted with a thermal safety device that stops the appliance from heating in the event of incor-
rect use or irregular operation. Once the appliance has cooled, using a toothpick or similar, delicately press
the safety device reset button (W) marked RESET (see Fig. 1). If the appliance does not start operating again,
contact a service centre authorised by the manufacturer.
OPERATING INSTRUCTIONS
Before using the deep fryer for the first time, carefully clean, using warm water and dishwashing detergent,
the basket, the bowl and the cover. The control unit, power cable and heating element may be cleaned using
a damp cloth. Check that water does not enter into the control unit and that there is no residual water in the
bottom of the removable bowl. Carefully dry all the parts.
Check that the control unit is properly fastened to the deep fryer body. The safety micro-switch (H) will pre-
vent the appliance from operating unless the control unit is correctly positioned (N).
fryer, figure 9. If the magnetic connector does not
remain in place, check that it has been inserted cor-
rectly, (see figure 8). If the problem persists, contact
an authorized service center. When the appliance is
in operation, always leave free space around the
magnetic connector to prevent it from becoming
detached. Use type MC-316 cords provided by a
De'Longhi authorized service center only.
KEEP OUT OF REACH OF CHILDREN
M. Basket support
N. Slot for fitting the control unit
O. Handles
P. Casing
Q. Oil drain tap (if fitted)
R. Oil drain tap cover (if fitted)
S. Cover with handle
T. Filter (if present)
U. Viewing window (if present)
V. Electrical heating element
W. Thermal safety device reset
X. Filter oil
5