Before The First Use - Linea Domo PRO DO1091TD Manual De Instrucciones

BEFORE THE FIRST USE

· Check that the trimmer is working properly before use.
· Check that the blades are clean before use.
· You must oil the blades before each use.
USE
1. Only use the trimmer on clean, dry, and untangled hair.
2. Set the desired trim height. Use the slider on the trimmer for a shorter length
(0.5-2.5 mm). For a longer length, use one of the 6 comb attachments; see
'comb attachments' section.
3. Press the on/off button.
4. Place the trimmer flat against the head with the blades pointing in the direction
of hair growth. Move the trimmer up and out through the hair. Never force the
trimmer through the hair. Never switch off the trimmer while it is in the hair.
5. When you have finished trimming your hair, press the on/off button again to
turn the trimmer off.
COMB ATTACHMENTS
· The trimmer comes with 6 combs for trimming and 1 comb for thinning. You can
read the trim height on the comb: 4-6 mm, 7-9 mm, 10-12 mm, 16-18 mm, 22-24 mm, and 28-30 mm.
Use the slider to set the trimming height within these dimensions, e.g. if you want to trim to a length
of 10 mm, insert the 10-12 mm comb attachment and set the slider to 0.5 mm.
· If the hair has to be shortened a lot, do it gradually. Start with a longer length and select a comb
attachment with a shorter trim height each time. Turn off the trimmer
before changing the comb attachment.
· Place the desired comb attachment on the trimming head before turning
the trimmer on. Make sure that the teeth of the comb attachment
are pointing upwards. First, place the blades on the teeth of the comb
attachment and then click the bottom of the comb attachment onto the
clipper (see illustration).
· Remove the comb attachment by pulling the sides that lock onto the
trimmer open slightly, and then remove the comb attachment from the
trimmer.
CHARGING
· You can read the remaining battery life on the display. This indication goes from 00 to 60 minutes in
5-minute intervals. When the battery level reaches 05 min, the LED will turn red instead of blue. Allow
the trimmer to charge.
· Plug the power cord into a socket. Connect the trimmer directly to the adapter or connect the
charging station to the adapter and place the trimmer on the charging station.
· If you connect the trimmer directly to the adapter, you can continue to use the trimmer. Do not use
the trimmer for a long time in this way, as this could damage the adapter and even cause a fire.
· When the trimmer is charging, you can see the bars on the display flashing. It takes an average of one
hour to fully charge the battery.
24
DO1091TD
1
2