Stinger SPX350.2 Manual página 3

Amplifier Owner's Manual
SPX350.2
2 Channel Bluetooth Power Amplifier
RCA INPUT OPTIONAL*
Connect preamp signal cables from the head to RCA inputs in
harness.
BLUETOOTH*
Stream directly to ampifier directly from Bluetooth enabled
devices
Bluetooth input is default input, if switching between RCA and
Bluetooth input, disconnect or turn off Bluetooth from streaming
device, RCA input will automatically become active.
RCA OUTPUT
Provides a full range signal for an additional amplifier. There is no
signal loss if using this output.
CROSSOVER FREQUENCY
Controls the crossover point for the speaker outputs, 40Hz-400Hz
Low or High Pass
12V+
This must be connected to the fused positive terminal (+12V) of
the car's battery. The fuse must be located within 18 inches of the
battery.
Recommended fuse rating is 30 amperes.
REMOTE
This must be connected to switched +12V, usually a trigger wire
coming from the head unit or ignition. This is not used if using Hi
input auto on feature.
GND
This must be connected to the negative terminal of the car's
battery or bolted to a clean, unpainted part of the chassis of the
LEVEL
Used to reach maximum amplifier power with a wide variety of signal
sources.
HI INPUT
Connect a factory system's headunit or amplifier outputs. No LOC neeeded.
REMOTE LEVEL CONTROL (REMOTE)
This port is for connecting the optional remote level control This allows up to
20dB of volume adjustment.
SPEAKER OUTPUTS
Used to connect the amplifier to speakers. PSX350.2 minimum impedance is
2 ohm stereo or 4 ohm mono.
© 2016 Stinger • www.stingerelectronics.com