Publicidad
Idiomas disponibles
Idiomas disponibles
DM 2615302558 8/98
1/11/99 1:48 PM
10. Edge guide is used for shaping edges,
cutting rabbets, dadoes, mortise, tongues,
grooves, slots, and chamfers. Remember to
feed so the cutter tends to pull the edge
guide against the wood. A consistent feed
rate gives a smooth cut.
11. In general, several shallow cuts should
be used when a deep groove is desired.
Maximum depth of cut will vary depending
on material used. Do not over feed to an
amount that the motor is noticeably slowed.
Fig. 1
EDGE GUIDE
Fig. 2
Page 7
12. Certain circular cuts can be made using
the edge guide bracket. Radii from 1 11/16"
to 4" can be done. Remove the edge guide
and attach the edge guide bracket to the
guide rods. Use the finishing nail provided as
a compass point. Set the edge guide bracket
for the desired radius. Place the nail through
the hole in the bracket and place the nail at
the center of the desired radius to be cut.
DESIRED DISTANCE
OF LESS THAN 1 3/4"
DESIRED DISTANCE
1 1/4" TO 4"
RADIUS
-7-
Publicidad
