Before You Begin - H+C waterware DH454530 Instrucciones Para La Instalación

BEFORE YOU BEGIN: Read this important
information.
1. Shut off main water supply before installation.
2. Check to make sure you have the following parts
indicated below:
1. Spray Head
2. Spout Assembly
3. Metal Handle Assembly
4. Mounting Hardware Assembly
4.1. Rubber Washer
4.2. Metal Washer
4.3. Lock Nut
Step 1. Install Faucet
A. Install faucet body through top of sink.
NOTE: For 3-Hole installation, the deck plate
for Pull Out (DH455010,DH455020) is optional.
If needed, refer to drawing A-2 (Place silicone
sealant beneath the plastic gasket during
installation).
Danze, Inc. / 2500 Internationale Parkway / Woodridge, IL 60517
2
INSTALLATION, CARE AND CLEANING
2.
1.
4.1.
4.
4.2.
4.3.
DH454530 Shown
www.hcwaterware.com
Pull Out/Pull Down Kitchen Faucet
Tools and Supplies you will
need to complete your
installation
Adjustable Pipe tape
wrench
3.
Phillips
Silicone
screwdriver
sealant
1-Hole Installation
3-Hole Installation
INSTRUCTIONS
FOR YOUR NEW
Groove joint Hex wrench
pliers
Supply hoses or tubes
with1/2" coupling nuts to
connect faucet to water
supply valve
A-1.
Optional deck plate (to cover existing
mounting holes in the sink deck).
NOTE: DO NOT REMOVE SPRING CLIP
FROM HOSE UNTIL STEP 2-D.
A-2.