Veranda 34107832BOM Manual Del Usuario página 5

Top Bracket Covers:
8
a. Ensure the railing is centered between both posts
and tighten the set screws put into the metal
brackets from Step 4.
b. Open the top rail bracket cover to allow it to wrap
around the top rail (Fig. 10). While open, make sure
the "tab" ts behind the rail and against the post
(Fig. 11).
c. While tightly squeezing the bracket cover closed,
pre-drill using a
underneath. Then, drive two #10 x 1
screws through the cover, metal bracket and into the
top rail (Fig. 12).
For Bottom Brackets:
9
a. Center rail on post. Then, using a
drill the rst hole on an angle though the bottom rail
bracket, vinyl post jacket, and into wood post
(or plastic spacer of post install kit).
b. Install the #10 x 1
Bottom Bracket Covers:
10
Slide bottom bracket covers snugly onto bottom brackets
(Fig 14).
⁄ ⁄ " drill bit through the two holes ⁄ ⁄
5 5 5
32 32
⁄ ⁄ ⁄ ⁄ " drill bit, pre-
5 5 5
32 32
⁄ ⁄ ⁄ ⁄ " square drive screws (Fig. 13).
1 1 1
4 4
⁄ ⁄ " square drive ⁄ ⁄
1 1 1
4 4
Top rail bracket cover
Tab
Predrill and install screws
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
5