Intermec P1601 Instrucciones De Uso página 14

sun, etc.) or to extreme temperatures.
• Always disconnect the appliance from the mains supply before
cleaning or performing maintenance and when the appliance is not
EN
in use.
• If the appliance is faulty or malfunctions, switch it off and do not
tamper with it. Contact an authorised technical service centre for
any repairs.
• If the supply cord is damaged it must be replaced by an authorised
technical service centre, so as to prevent all risks.
• When the appliance is used in a bathroom, unplug it after use since
the proximity of water presents a hazard even when the appliance
is switched off.
• For additional protection, the installation of a residual current device
(RCD) having a rated residual operating current not exceeding 30
mA (ideal 10 mA) is advisable in the electrical circuit supplying the
bathroom. Ask your installer for advice.
• This appliance shall not come into contact with water, other
liquids, spray, steam. For any cleaning and maintenance operation
refer to the instructions in the relevant chapter.
• DO NOT use this heater in the immediate surroundings of a bath,
a shower or a swimming pool.
• DO NOT use this appliance near a washbasin or a sink filled with
water. During use the appliance must be placed in such a way that
it cannot fall in the washbasin or the sink.
• This appliance must not be located immediately below a socketoutlet.
• DO NOT leave this appliance in contact with or near materials
and surfaces that are easily flammable or can be damaged by heat.
• Use this heater on a horizontal and stable surface, or fix to the wall,
as applicable.
10